解決Kloxo-MR錯誤提示問題：Error 404 – Not Found

解決Kloxo-MR錯誤提示問題：Error 404 – Not Found

The requested page could not be found but may be available again in the future

找不到請求的頁面，但將來可能會再次可用

If you are seeing this page, it means that web has not been configured for this domain on this server.

This could be due to the following causes:
Kloxo has not restarted the web server yet after you added the domain. Please wait for the web server to restart.

The domain is pointing to the wrong Kloxo server. Ping the domain and make sure that the IP matches one of the IPaddress seen in admin home -> ipaddresses

If you are seeing this page when you try to access an IP like http://192.168.1.1, then that means that the IP has not yet been mapped to a domain. Go to client home -> ipaddresses -> ipaddress home -> domain config and map an IP to a domain.

Once you map an IP to a domain, then you have to make sure that the domain pings back to the same IP. Otherwise, if you try to access the domain, you will get this page. So IP -> domain.com should mean that domain.com pings to the same IP.

如果你看到此頁面，則表示該服務器上尚未為此域配置網絡。

這可能是由於以下原因：

• Kloxo在添加域後還沒有重新啟動Web服務器。請等待Web服務器重新啟動。
• 域指向錯誤的Kloxo服務器。
• ping域，並確保IP匹配在admin home – > ipaddresses中看到的IP地址之一。

如果你在嘗試訪問IP http:// 192.168.1.1 時看到此頁面，則表示該IP尚未映射到域。

• 轉到：admin — IP地址— {配置域名}，並將IP映射到域。

選擇更新for eth0

域名：Ufo.org.in、img.Ufo.org.in

• 嘗試刷新ufo.org.in、img.ufo.org.in
• 若還是有錯誤，就輪流切換域名選擇或選擇“Disabled”

重啟httpd：

service httpd restart

重啟httpd後選擇“Disabled”，生效了。

將IP映射到域後，你必須確保域ping回相同的IP。否則，如果你嘗試訪問域名，你將獲得此頁面。所以IP – > domain.com應該意味著domain.com呼叫到同一個IP

以上方法嘗試多次了，還是有問題，請輸入如下修復命令：

yum clean all; yum update -y; sh /script/cleanup